分光光度法研究铝制品对水样溶出铝含量的影响

采用分光光度法,在pH为3-4的酸度条件下,以二甲酚橙为显色剂,快速检测水样中微量铝的含量.研究了不同情况下不同铝制品对水样溶出铝含量的影响.结果表明:水样在铝制品中放置时间越长,从铝制品中溶解出的铝越多,而且薄的铝制品中溶出的铝要比铝合金锅中溶出的多;当在水中加入一定量的食盐后,由铝制品中溶解出的铝含量明显增多.本方法简便快速,灵敏度高,对样品测定的结果令人满意.     

A new rule of vibration sampling for predicting acoustical radiation from rectangular plates

Structural surface velocity distribution is often used to predict structural borne sound radiation. However the sampling interval of velocity should be chosen carefully to increase the prediction accuracy and to reduce the system cost. In this paper, several factors affecting the sampling interval are theoretically analyzed and discussed for a vibrating baffled rectangular plate. A new rule for the determination of the sampling interval is formulated. Using this rule, the results from both numerical simulations and experiments may be explained well.     

Atomic distributions in acetylene-air flame using hydraulic high-pressure nebulization with direct (100%) introduction of solutions Applications to speciation analysis

One of the fundamental factors of the performance of atomic spectrometric methods is the efficiency of sample introduction into flame or plasma. By utilization of the formerly developed hydraulic high-pressure nebulizer, a nebulizer/burner system with solution uptake efficiency of 100% have been worked out. Optimizing operation parameters of nebulizer/burner system, an improvement of 2-12 times was achieved for the signal-to-noise ratio in the flame emission and flame atomic absorption spectrometry, depending on sample flow rate. This nebulizer is especially suitable for development of liquid chromatography-AAS/FES coupled technique for speciation analytical tasks.     

A highly selective solid phase extraction sorbent for pre-concentration of sameridine made by molecular imprinting

Summary A novel approach to solid phase extraction, based on the use of a highly selective molecularly imprinted polymer, is presented. The versatility of this type of sorbent for solid phase extraction was demonstrated in a model batch-wise pre-concentration of sameridine prior to gas chromatography. Problems associated with leakage of remaining imprint molecules during the desorption phase could be eliminated by the use of a close structural analogue of sameridine as the imprint species. It was found that a major benefit of the imprinted polymer was its specificity, which lead to distinctly cleaner chromatographic traces and ability to improve sensitivity by extracting sameridine from larger sample volumes.     

Membrane introduction mass spectrometry

An overview of membrane introduction mass spectrometry (MIMS) is presented and comparisons are made with other direct sample introduction techniques. Special attention is given to the unique advantages and the limitations of newer variants on the MIMS technique, including affinity MIMS, reverse-phase and trap MIMS. The salient features of the interfaces used in MIMS are summarized and the various membrane materials commonly used are delineated. The applicability of MIMS is illustrated via discussion of

1. (i) bioreactor monitoring (represented by yeast fermentation),

2. (ii) environmental monitoring (illustrated by analysis of contaminated ground water samples) and

3. (iii) on-line chemical reaction monitoring (exemplified by the photolysis of aryl esters).

The applicability of MIMS to the analysis of environmental samples, including complex mixtures in water, air and soil, is noted.     

Uniformity in radon exhalation from construction materials using can technique

The uniformity in radon exhalation rates for 46 tiles of granite, marble and ceramic used as construction materials were determined using “Can Technique” employing CR-39 nuclear track detectors (NTDs). On each tile, two sealed cans, each enclosing one NTD fixed at the center of the tile surface area covered by the can, were mounted at two different locations of each individual tiles. The track production rates on the NTDs representing radon exhalation rates were measured. The radon exhalation rates from the surface of individual tiles showed uniform exhalations within the calculated uncertainties of the measured values. This makes Can Technique an alternative simple method to measure radon exhalation rates. Calibration required to convert track production rates into radon exhalation rates for the used can and NTD was done using an active technique. The correlation between the measurements by the two techniques shows a good linear correlation coefficient (0.83).     

Multiporous hollow polymer particles

Hollow particles with interconnected cavities have been prepared by a simple modified suspension polymerization of acrylate monomers in the incorporation of a phase inversion process and polymerizable emulsifier. The morphology of particles has been characterized by scanning electron micrographs (SEMs). Based on observations made using an optical microscope equipped with a digital camera and SEM images of particles obtained under different conditions, the formation mechanisms for multiporous hollow particles are discussed.     

New methodologies in trace analysis of volatile organic compounds

Two methods for sampling and concentration of volatile organic compounds are reported. In the first method, traps coated with a very thick film (ca. 100 μm) of cross-linked silicone stationary phase are employed. Such thick films can be prepared with a modified dynamic coating procedure, which is briefly described. The low phase ratio traps can be utilized for enrichment of volatiles from gaseous as well as aqueous matrices. The second technique is based on chromatographic evaporation of a solvent in a capillary tube, where the process is sustained by a repeated sample injection and a cyclic flow reversal. In this way, large solvent volumes can be handled by a small volume system. Under optimal conditions, when using a solvent barrier, quantitative recovery is possible even for compounds of comparatively high volatility. Another important application of the technique is extraction of trace components from gases such as headspace samples, polluted air, etc.     

Imaging of wood tissue by ToF-SIMS: Critical evaluation and development of sample preparation techniques

Tissue of Norway spruce wood was investigated by time-of-flight secondary-ion mass spectrometry (ToF-SIMS) and field-emission scanning electron microscopy (FE-SEM). Different sample preparation techniques (including sectioning and drying) traditionally used for SEM analysis were compared and critically evaluated. A high contamination of wood surfaces by polytetrafluoroethylene (PTFE) introduced onto the sample during sectioning was detected by ToF-SIMS. A new protocol was developed and images of wood sections dried in different ways were compared. Main location of Mg, Na, K and Ca, but no lignin in membranes of bordered pits in spruce section surfaces was detected by ToF-SIMS imaging if critical point drying (CPD) or acetone extraction followed by drying under nitrogen flow (AEND) was applied. No specific locations of wood components as well as low signals from metal ions (Mg and Na) were observed on the wood surfaces of freeze-dried (FD) or air-dried (AD) sections. It was found that extractive substances, presenting on surfaces of FD and AD wood section, were evenly distributed on the surfaces and interfered with ToF-SIMS analysis. Our results indicated that ToF-SIMS imaging was critically sensitive to the sample preparation technique and a strict protocol for characterization of metals, lignin and polysaccharides in wood was suggested.     

电热蒸发进样微波等离子体炬原子发射光谱法中共存元素的影响

本文考察了以微波等离子体炬（MPT）为光源，电热钽丝环进样时，溶液中共存元素对发射信号的影响。